Differences

This shows you the differences between two versions of the page.

--- tech:rear [2022/02/10 08:19] – mtbtimeline
+++ tech:rear [2023/09/09 12:14] (current) – mtbtimeline
@@ Line 79: / Line 79: @@
 Shuler Victor [[http://mombatbicycles.com/MOMBAT/BikeHistoryPages/Shuler.html|mombat]]
 </div>
+<div column 50% #rear1a>
+=== 1988 Moulton AM-ATB ===
+Leading link front, rubber bumpers rear and foldable for transport.  Partially made by [[kuwahara:start|Kuwahara]].  Arguably the first "mass produced, full suspension mountain bike."
+\\
+Shimano 600SIS (1986-87), which only has a 28T capacity.  20" wheels.  Only 361 AM-ATBs made between 1988 -> 1992.((See more at: [[http://mombatbicycles.com/MOMBAT/Bikes/1989_Moulton_ATB.html|mombat]].))
+</div>
+<div column 45%>
+{{moulton.jpg?360|1988 Moulton AM-ATB}}
+\\
+Moulton AM-ATB [[http://www.bicyclemuseum.com/?s=moulton|bicyclemuseum]]
+</div>
 <div column 50% #rear1b>
@@ Line 106: / Line 127: @@
 === 1990 Offroad Pro-Flex RF-1 ===
-The //"first commonly available full-suspension mountain bike"//(([[http://mombatbicycles.com/MOMBAT/BikeHistoryPages/ProFlex-Girvin.html|mombat]] October 1990 Bicycling review)).  Elastometer single pivot rear with an Offroad Flex-Stem on the front, which counts as front suspension.  $1500, 28 pounds, 2 inches of rear travel.
+The //"first commonly available full-suspension mountain bike"//(([[http://mombatbicycles.com/MOMBAT/BikeHistoryPages/ProFlex-Girvin.html|mombat]] October 1990 Bicycling review, which ignores the Moulton - which was not widely distributed.)).  Elastometer single pivot rear with an Offroad Flex-Stem on the front, which counts as front suspension.  $1500, 28 pounds, 2 inches of rear travel.
@@ Line 159: / Line 180: @@
 Four pivots.  Front air-oil damping, elastometer rears.
-Despite its name, the RS-1 did not use Rockshox RS-1's((However, the 1990 prototype RS-1 did use the RS-1 front shocks.  See: [[https://mbaction.com/throwback-thursday-mountain-bike-suspension-from-30-years-ago/|mbaction]]))  Note the very early use of disc brakes, using [[https://www.hopetech.com/history/the-nineties/|Hope]] disc brakes ((Hope discs have a spiral patter of holes, while Pro-Stops, used on later RS-1's, used a slot pattern of rotor cooling.)) and their matching hubs.
+Despite its name, the RS-1 did not use Rockshox RS-1's((However, the 1990 prototype RS-1 did use the RS-1 front shocks.  See: [[https://mbaction.com/throwback-thursday-mountain-bike-suspension-from-30-years-ago/|mbaction]]))  Note the very early use of disc brakes, using [[https://www.hopetech.com/history/the-nineties/|Hope]] disc brakes ((Hope discs have a spiral pattern of holes, while Pro-Stops, used on later RS-1's, used a slot pattern of rotor cooling.)) and their matching hubs.
 Mert Lawwill's((The inventor of the [[lawwill:start|Lawwill]] Pro-Cruiser)) father's personal bike.
@@ Line 351: / Line 372: @@
 \\
 Cannondale Fulcrum DH [[https://www.theproscloset.com/blogs/news/five-vintage-full-suspension-bikes|theproscloset]]
+</div>
+<div column 50% #s1940>
+----
+=== 1940 Randonneur ===
+Suspension pre-history and of mountain biking in general.  Very early full suspension French randonneur.
+\\
+Steel frame with lugs and brass fillets.  Super Rapid 3-speed rear derailleur and shifters.  Wooden rims.  Front and rear spring shocks with rear pivots at both the bottom bracket and dropouts..
+</div>
+<div column 45%>
+{{1940.jpg?300|1940 Randonneur }}
+\\
+Randonneur
+[[https://steel-vintage.com/products/original-prototype-randonneur-silver|steel-vintage]]
 </div>